Wire Wrapped Pendant Project

Supplies:

• one ceramic pendant with hole
• approximately 8 inches of 20 gauge wire

Start by sliding the wire half way through the hole of the pendant.
With one end of the wire, wrap it around the pendant When doing so, try to conceal the hole.
Bring the second end of the wire to the top of the pendant.
Make a small wire loop, do not trim the excess wire.

Finish the pendant by wrapping the remaining wire around the pendant.

If you have sharp edges on your wire, you can turn the ends into the pendant.

Post written by Jennifer Heynen a.k.a. Jennifer Jangles